volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing headlight range control motor > < Renewing side light bulb

Golf Mk6

Renewing front turn signal bulb
Renewing front turn signal bulb
  Note
t  There is no requirement to remove the headlight to change the front turn signal bulb.
t  The illustrations show the renewal of the front turn signal bulb for the left headlight.
t  The renewal of the front right turn signal bulb for the right headlight is carried out in the same way.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
   
–  Remove cover cap -1-.
  N94-11574
–  Turn bulb holder -1- in direction of -arrow- and pull front turn signal bulb backwards out of headlight.
  N94-11575
–  Press lock button -arrow- and pull front turn signal bulb-1- upwards out of bulb holder.
  Note
The front turn signal bulb is permanently attached to the bulb holder and cannot be dismantled.
Front turn signal bulb: 12 V, PSY 24 W SV
Installing:
  Caution
When installing cover cap, ensure cap is seated correctly. The ingress of water will lead to permanent damage to the headlight.
  Note
Do not touch bulb glass when fitting bulbs. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over.
Installation is carried out in the reverse order. When installing observe the following:
  Note
t  To lock the bulb holder, there are two locking lugs of different lengths in the reflector.
t  Insert bulb holder together with front turn signal bulb into reflector so that the longer locking lug points upwards.
–  Check headlight functions.
  N94-11576

Removing and installing headlight range control motor > < Renewing side light bulb