volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing windscreen washer fluid level senderG33 > < Removing and installing washer fluid reservoir (GTI)

Golf Mk6

Removing and installing windscreen and rear window washer pumpV59
Removing and installing windscreen and rear window washer pump -V59-
  Note
Depending on equipment, the fitting location of the windscreen and rear window washer pump -V59- may differ slightly from the illustration. Removal procedure is analogue.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
Only vehicles with auxiliary heating:
–  Remove front right wheel housing liner → General body repairs, exterior; Rep. gr.66.
Only vehicles without auxiliary heating:
–  Depending on equipment, remove either right cover in bumper cover or right fog light → Chapter.
Only vehicles in GTI equipment variant:
–  Remove front bumper cover → General body repairs, exterior; Rep. gr.63.
Continuation for all vehicles:
  Note
The connections to the pump and hose lines are colour-coded in order to prevent the washer fluid lines being incorrectly connected to the front and rear washer fluid pump -V59-. The hose fittings must be connected to the correct colour-coded pump connections during installation.
   
–  To release, turn securing clips at hose connections -3- and -5- and pull these off windscreen and rear window washer pump -V59--4-.
–  Drain any escaping fluid in a suitable container.
–  Pull windscreen and rear window washer pump -V59--4- upwards out of reservoir.
–  Release and disconnect connector -2-.
Installing:
Install in the reverse order of removal. When doing this, note the following:
–  Tighten all threaded connections to torques specified in assembly overview → Chapter.
–  On completion of installation work, bleed headlight washer system → Chapter.
  N92-10095

Removing and installing windscreen washer fluid level senderG33 > < Removing and installing washer fluid reservoir (GTI)