Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Vehicle electrics | Electrical system | Wiring | Control units | Trailer detector control unitJ345 | Removing and installing trailer detector control unitJ345

Removing and installing trailer detector control unitJ345

Removing and installing trailer detector control unit -J345-

The trailer detector control unit -J345- is located behind the left side panel trim in the luggage compartment.

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1783-

Removing:

–	Switch off ignition and all electrical consumers and remove ignition key.

–	Remove left side panel trim from luggage compartment → General body repairs, interior; Rep. gr.70.

–	Release connectors -2- and disconnect them from trailer detector control unit -J345-.

Note

The number of connectors at the trailer detector control unit -J345- may differ from the illustration, depending on vehicle equipment.

–	Remove securing bolts -1- and take trailer detector control unit -J345- together with bracket out of vehicle.

–	Remove securing bolts -arrows- and detach trailer detector control unit -J345- from bracket.

Installing:

Installation is carried out in the reverse order. When installing observe the following:

Note

Following installation, a new trailer detector control unit -J345- must be encoded → Chapter.

Volkswagen Workshop Service and Repair Manuals