volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Fuse holder in E-box > < Fuse holder in dash panel

Golf Mk6

Removing and installing fuse holder in dash panel
Removing and installing fuse holder in dash panel
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1410-
  W00-0554
t  Removal wedge -VAS 3409-
  Caution
When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed → Chapter.
Removing:
–  Disconnect battery → Chapter.
  W00-0016
–  Remove side cover -1- of dash panel by inserting removal wedge -VAS 3409- or a suitable screwdriver in recess -2- and levering off side cover -1- in direction of -arrow-.
  N97-10076
–  Remove securing bolts -arrows- and take off fuse holder -1- from bracket, taking connected wiring length into consideration.
Installing:
Installation is carried out in the reverse order. When installing observe the following:
–  Tighten securing bolts to specified torque of 4 Nm.
  N97-10383

Fuse holder in E-box > < Fuse holder in dash panel