Golf L4-2.0L (AEG) (1999)
-
Installing refer to Fig. 1
9. Bushing
-
Only installs in one position
10. Gate selector housing
-
Install into mounting plate after installing the complete gear lever
11. Bushing
12. Spring
13. Guide bushing
-
Locate on bushing -15-
14. Lock washer
-
Removing refer to Fig. 3
15. Circlip
-
Removing and installing refer to Fig. 2
16. Spacer sleeve
17. Spring
18. Shift lever
19. Damper
20. Spring clip
Fig. 1 Installing cap
-
Press on from side (arrow -1-)
-
Press opening together to form a slot.
Note:
-
If necessary heat cap (e.g. with hot water).
Fig. 2 Removing and installing circlip
-
To remove and install the circlip pull gear lever in direction of arrow -A- and at the same time push down spacer bushing onto stop using
screwdriver in arrow direction -B-.
Note:
-
Do not tilt spacer bushing when pushing down. Carefully release pressure at groove in gear lever for circlip.