Golf GL L4-2.0L (AEG) (2001)
1. 2 Self-locking 12-point nut
-
Tightening
-
Any paint residue and/or corrosion on thread of outer joint must be removed before nut is installed.
CAUTION: The vehicle must be standing on its wheels when loosening or tightening the 12-point nut. Otherwise there is a risk of an accident.
3. Axle shaft, right and left (tube shaft)
-
Left axle shaft is shorter!
4. Bolt
-
Always replace
-
M8 x48: 20 Nm (15 ft. lbs.) + 90°
-
M10x52: 50 Nm (37 ft. lbs.) + 45°
-
The initial tightening torque of the bolts M8 and M10 must be carried out in two steps. First apply a torque of 10 Nm and then the
corresponding torque.
5. Plate
6. Hose clip
-
Tightening see Fig. 9
-
Always replace
7. Protective boot for inner CV joint
-
Material: Hytrel (Polyelastomer)
-
No vent hole
-
Check for tears and chafing
-
Drive off CV joint using drift
-
Before installing on CV joint, coat sealing surface with D 454 300 A2.
8. Protective boot for inner CV joint
-
Material: Rubber
-
With vent hole
-
Check for tears and chafing