Golf GTI L4-1781cc 1.8L SOHC (RD) (1987)
/Page-1546001.png)
Tie Rod Boot: Technical Service Bulletins
Tie Rods and Boots - Removing/Installing
GROUP
48
NUMBER
89-04 October 31, 1989
MODEL(S):
Golf/Jetta, from 1985 m.y.
SUBJECT:
Tie rods and boots, removing/installing (Power steering only)
CAUTION
Power steering gear seals and sliding parts must be kept free of dust and moisture. Any contamination, either from a leaking boot, or through careless
service procedures, can lead to scoring of the toothed rack, and eventual gear leakage. A leaking gear must be replaced as an assembly.
Always follow these "rules" for cleanliness when repairing the power steering system:
1.
Clean connections and surrounding area thoroughly before loosening.
2.
Place parts removed on a clean surface and cover them. Use plastic, paper or lint-free cloths.
3.
Carefully cover opened components or plug openings if repair is not going to be done immediately.
4.
Install clean parts only.
^
do not remove replacement parts from packaging until just before installation
^
do not use parts that were stored unpacked
5.
When the power steering hydraulic system is opened:
^
do not use compressed air in the immediate area
^
do not move the vehicle unless absolutely necessary
The following tie rod and boot removal/installation information, supplements procedures covered in the current repair manual microfiche.
Removing
CAUTION
To avoid damage to the rack and pinion DO NOT attempt to remove tie rod from an installed gear.
^
seal hydraulic ports in steering gear, as follows:
