Golf III L4-1984cc 2.0L SOHC (1993)
Rear Door Window Regulator: Service and Repair
Regulator Repair/Servicing
The following images and procedures are for servicing the front window regulator assembly.
Servicing the rear window regulator follows the same principle.
-
Remove door trim.
-
Partially remove vapor barrier.
-
Remove door window .
-
Remove window regulator.
CAUTION:
-
Do not damage vapor barrier.
-
Water leaks will occur if damaged vapor barriers are installed.
-
Always replace damaged vapor barriers.
-
Do not wrinkle vapor barrier when installing.
-
Water leaks will occur if vapor barriers are wrinkled when installed.
Procedures:
-
Remove two (Torx T10) bolts -1- from window regulator and motor assembly and install into window regulator at (arrows) to secure base plate to
window regulator.
NOTE: These bolts remain on the window regulator.
-
Remove all remaining bolts, items -1- and -2- (Torx T10 and Torx T25).
-
Remove window regulator from motor in direction of arrows.
