Golf III L4-1984cc 2.0L SOHC (1993)
7. Remove any bolts/nuts retaining wiper frame assembly.
8. Remove wiper assembly from vehicle. Use caution not to damage seals when withdrawing pivot bushing.
9. Disconnect wiper linkage from motor crank arm and wiper pivot shafts.
10. Noting position of O-rings and washers, remove C-clip from pivot shaft, then slide pivot shaft out of bushings.
11. Remove motor mounting bolts/nuts, then motor.
12. Reverse procedure to install, noting the following:
a. Prior to installing motor, connect motor to vehicle electrical connector, turn ignition on, then turn wiper on and off to ensure motor is in Park
position.
b. Turn ignition off, then disconnect electrical connector.
c. Ensure wiper linkage is in Park position. If necessary, remove and position crank arm on motor to correct alignment.
d. Install motor and mounting bolts/nuts, then torque to 14 ft. lbs.
e. Torque wiper pivot shaft bushing mounting nut to 62 inch lbs.
f.
Torque wiper arm mounting nut to 12 ft. lbs.
