Golf III L4-2.0L (ABA) (1995)
Exhaust Pipe: Service and Repair
Intermediate Pipe
LEGEND
1
Nut
2
Locking Clamp
3
Intermediate Pipe
4
Bracket
5
Bolt
6
Front And Rear Muffler
7
Dimension -c-
8
Marking For Double Clamp (to Be Used When Replacing One Of The Mufflers)
9
Cutting Point
10
Dimension -b-
11
Marking
12
Retaining Ring
13
Bracket
14
Nut
15
Bracket
NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.
COMPONENT NOTES
Nut (1)
-
Tighten to: 40 Nm (30 ft. lbs.).
Bolt (5)
-
Tighten to: 25 Nm (18 ft. lbs.).
Front And Rear Muffler (6)
-
Available as separate replacement parts.
-
Cut connecting pipe at right angle at point -10- inset-A-.
-
Connect front and rear muffler with double clamp.
-
Slide double clamps toward mark -8- inset-B-.
Dimension -c- (7)
-
Approximately: 10 mm (0.39 inch).