Golf III L4-2.0L (ABA) (1995)
Fig. 7 Operating rod, unhooking from manual selector valve
-
Turn manual selector valve -1- so that shoulder is to operating rod.
-
Guide operating rod -2- with manual selector valve into valve body.
Fig. 8 Operating rod for manual selector valve, adjusting
-
Move selector shaft to position "P".
-
Push operating rod with manual selector valve into valve body up to stop (direction of arrow) and tighten bolt to 4 Nm (35 inch lb).
NOTE:
^
Manual selector valve must always be resting against the stop.
^
Counter-hold in direction of arrow when tightening bolt.
^
Always replace bolt and manual selector valve retaining clip.
Fig. 9 Valve body, installing
-
Route conductor strip as illustrated, when installing do not kink or twist.
NOTE: When installing do not kink or twist the conductor strip.
Fig. 10 ATF screen, installing
-
Before installing ATF screen install seal in valve body.
-
Firmly press ATF screen onto valve body.