Golf III L4-2.0L (ABA) (1995)
7
- Gasket
- Always replace
- Press into ATF screen
8
- Bolt
- Tightening torque: 5 Nm (44 in lb.).
9
- Valve body
- Marking Fig. 6
- Installing with wiring harness - Fig. 2
- Installing with conductor strip - Fig. 3
10 - Bolt
- Tightening torque: 10 Nm (7 ft lb.)
11 - Cable gland
- Insert with O-ring
12 - O-ring
- Always replace
13 - Cable connector
- Attach to starter
14 - Clip
15 - Clip
16 - Nut
- Tightening torque: 10 Nm (7 ft lb.)
17 - Sealing plug
- Take out before removing and installing free wheel
- Insert so that lug is located in groove on housing - Fig. 1
- Place O-rings onto sealing plug
18 - O-ring
- Always replace
19 - O-ring
- Always replace
20 - Operating rod for manual selector valve
- Adjusting Fig. 4
- Install with stepped side facing manual selector valve
Fig. 1
Fig. 1 Installing sealing plug
- Remove the sealing plug from the housing before removing and installing the free wheel, otherwise the sealing plug and the O-ring will be
damaged.