Golf III L4-2.0L (ABA) (1995)
Input Shaft: Service and Repair
NOTE:
-
When installing new gears, consult Applications and ID
-
Vehicles with 2.0 liter 85 kW (115 hp) engine: the input shaft incorporates larger dimensions for the following:
^
Splines for clutch disc
^
Input shaft oil seal
^
Front needle bearing
1
Bolt--M17 (Always replace)
-
Engage both 5th and reverse to loosen or tighten
-
Coat threads with VW D6 locking fluid
-
Torque 150 Nm (111 ft lb)
2
Dished washer
3
Operating sleeve/synchronizer hub for 5th gear
-
Removing/Installing - See: Service and Repair/020 Transmission Disassembly - See: Service and Repair/020 Transmission Assembly
4
Stop ring
-
Prevents locking keys from moving out of position
-
Removing stop ring
^
Press pipe piece 2010 into synchronizer/stop ring while prying stop ring from synchronizer (stop ring must be fully on pipe piece 2010)
^
Remove stop ring together with pipe piece 2010