GTI L4-2.0L Turbo (BPY) (2007)
-
Release terminal lock using assembly tool with correct fit -A- and then pull wire with single wire seal toward rear -arrow- out of terminal housing.
-
Cut off the old terminal with single wire seal from the vehicle-specific wiring harness.
-
Slide repair wire with new terminal into corresponding chamber of terminal housing until it engages -arrow-.
-
Put single wire seal -A- on to free end of repair wire.
NOTE: When doing this, small diameter of single wire seal must point toward terminal housing.
-
Slide single wire seal -A- on to repair wire up to the terminal housing.