GTI L4-2.0L Turbo (BPY) (2007)
-
Drive new seal in as far as stop; be sure not to distort seal.
-
Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1
-
Insert flange shaft.
-
Secure flange shaft with countersunk bolt and tighten to torque specification.
-
Install left drive axle.
-
Install left front wheel housing liner.
-
Install wheel.
-
Check gear oil.
-
Install lower part of left front wheel housing line.
-
Install noise insulation.
Differentiating Transmission For Replacing Right Shaft Seal
Differentiating transmission for replacing right shaft seal (Rabbit/GTI) 02Q, 6 Speed M/T
Up to transmission build date 31 10 4, an intermediate shaft - arrow - is installed between the right drive axle - A - and transmission.
The intermediate shaft is attached onto a stub shaft - arrow -.
As of transmission build date 01 11 4, a flange shaft is installed at right - A -.
The intermediate shaft has been omitted.