volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Camshaft, Engine|Adjustments|Page 1619 > < Camshaft, Engine|Adjustments|Page 1617
Page 3
background image

-

Depress accelerator down to wide open throttle position.
Engine speed will be increased by engine control module to approximately 2300 rpm.

-

Hold brake pedal and accelerator down until display in display zone 3 jumps from "Test OFF" to "Test ON".

-

Continue to hold brake pedal and accelerator down until display zone 3 displays specification "Syst. OK."..

-

Release brake and accelerator pedals.

-

If System.OK." appears in display zone 3:

-

Press (arrow) key.

-

Check DTC memory:
Refer to Powertrain Management

-

Read readiness code:
Refer to Powertrain Management

-

Generate readiness code again if DTC memory has been erased or engine control module separated from permanent positive supply:

-

If no DTC is stored in DTC memory:

-

Press keys 0 and 6 for function "End output" and confirm entry with Q key.

-

Switch ignition off.

-

Check Camshaft Position (CMP) sensors -G40and -G163- (connections may be interchanged)

-

Check oil pressure, Refer to oil Pressure, Testing and Inspection

-

Check valve timing, Refer to Timing Components, Service and Repair.

-

When no faults can be located:

-

Replace intake camshaft timing adjuster, Refer to Camshaft, Engine, Service and Repair

-

If "Sys. OK " appears in display zone 3:

Check exhaust camshaft timing adjustment
-

Change to display group 96 as follows:

-

Press C key.

Indicated on display
-

Press keys 0, 9 and 6 for "Display group number 96" and confirm entry with Q key.

Indicated on display: (1...3 = display zones)
-

Depress brake pedal and hold.

-

Depress accelerator down to wide open throttle position.
Engine speed will be increased by engine control module to approximately 2300 rpm.

-

Hold brake pedal and accelerator down until display in display zone 3 jumps from "Test OFF" to "Test ON".

-

Continue to hold brake pedal and accelerator down until display zone 3 displays specification "Syst. OK.".

-

Release brake and accelerator pedals.

-

If "Sys. OK." appears in display zone 3:

-

Press (arrow) key.

-

Press keys 0 and 6 for function "End output" and confirm entry with Q key.

-

Switch ignition off.

-

If "Syst.n.OK." appears in display zone 3:

-

Press (arrow) key.

-

Check DTC memory:
Refer to Powertrain Management

-

Read readiness code:

Camshaft, Engine|Adjustments|Page 1619 > < Camshaft, Engine|Adjustments|Page 1617