GTI V6-2.8L (BDF) (2002)
/Page-517002.png)
-
Lubricate threaded head of oil seal extractor 3203, place it in position and exerting firm pressure screw it as far as possible into oil seal.
-
Loosen knurled screw and turn inner part against crankshaft until oil seal is pulled out.
Installing
Note: A PTFE seal (Teflon) -2- is gradually being introduced instead of the inner coil spring type seal -1-. This has a wider sealing lip. PTFE seals
are fitted free of oil and grease. When a PTFE seal is installed, then only such a seal may be installed as a replacement part!
-
Before installing, remove oil remains from crankshaft journal with a clean cloth.
-
Install guide sleeve T10053/1 onto crankshaft journal and carefully slide seal onto guide sleeve
-
Press seal against limit stop using press sleeve from 3266. Use old mounting bolt for vibration damper for this purpose.
