Jetta L4-1.9L DSL Turbo (BEW) (2004)
Drive Belt: Service and Repair
Ribbed Belt, Removing and Installing
Ribbed Belt, Removing And Installing
NOTE:
-
Always replace ribbed belt if found to be faulty. This will avoid related break-downs or operating problems.
-
If a used ribbed belt is to be reused, mark direction of rotation before removing. When installing used ribbed belts observe the direction of rotation
marked on removal. Installing opposite to the direction of rotation leads to belt damage.
-
It is not necessary to adjust ribbed belt tension. A spring loaded tensioner automatically adjusts belt tension.
Removing
Special tools and auxiliary items needed
-
Mandrel T10060
-
Remove bolts -arrows- and remove middle lower engine cover (noise insulation).
-
Remove nut, release clips -arrows- and remove right lower engine cover (noise insulation).
-
Mark direction of rotation of ribbed belt if it is to be reused.