Jetta L4-1.9L DSL Turbo (BRM) (2006)
‹› Replace
4
Gasket
‹› Replace
‹› Note installation position
5
7 Nm
6
Suspended mount
‹› Replace if damaged
7
25 Nm
8
Clamp
9
25 Nm
10
Retaining ring, front muffler
‹› Replace if damaged
11
Front and rear muffler
‹› For repairs, replace each separately
12
Suspended mount
13
Separating point
‹› For repairs
‹› Marked by three depressions around the circumference of the exhaust pipe
‹› At factory, front and rear mufflers are installed as a single component. Replacement front and rear mufflers are supplied separately.
‹› Use a clamp for connecting.
‹› Separating and joining front and rear mufflers --> [ Front and Rear Mufflers, Separating and Connecting ] See: Engine, Cooling and
Exhaust/Exhaust System/Muffler/Service and Repair/Front and Rear Mufflers, Separating and Connecting.
‹› Installation location, rear clamp (repair double clamp) --> [ Installation Location, Rear Clamp (Repair Double Clamp) ] See: Engine, Cooling
and Exhaust/Exhaust System/Muffler/Service and Repair/Front and Rear Mufflers, Separating and Connecting
‹› Evenly tighten the clamp threaded connections (repair double clamp).
‹› Clamp tightening specification (repair double clamp): M8 = 25 Nm
‹› Install exhaust system free of stress --> [ Exhaust System, Installing ] See: Engine, Cooling and Exhaust/Exhaust System/Service and
Repair/Exhaust System, Installing.
14
Suspended mount
15
40 Nm
16
Support
17
40 Nm