Jetta V6-2.8L (BDF) (2002)
Valve Cover: Service and Repair
Cylinder head cover, removing and installing
Special tools and equipment
^
T10095 Puller
^
VAG 1331 Torque wrench (5 50 Nm)
^
VAS 5024 Assembly tool for spring-type clips
^
Cable tie
Removing
CAUTION: When performing repair work, especially due to the confined conditions in the engine compartment, pay attention to the following:
^
Route all types of lines (e.g. for fuel, hydraulics, EVAP system, coolant, refrigerant, brake fluid and vacuum) as well as electrical wiring so that
the original positions are restored.
^
Ensure sufficient clearance to all moving or hot components.
Note: All cable ties which are opened or cut open during disassembly, must be replaced in the same position during installation
-
Remove engine cover.
-
Check whether a coded radio is installed. If so, obtain anti-theft coding.
-
With ignition switched off disconnect battery Ground strap.