Jetta V6-2.8L (BDF) (2002)
-
Disconnect connectors from ignition coils 1...6.
Note: Mark connector and component before pulling connector off.
-
Unclip ignition coils wiring harness from wiring guide.
-
Remove ignition coils with final output stage for cylinders 1 6 using puller T10095.
-
Pull off crankcase breather connecting hose between cylinder head cover and intake hose on cylinder head cover.
-
Remove intake hose between Mass Air Flow (MAP) sensor and throttle valve control module: See: Intake Manifold/Service and Repair
Note: Press buttons on hose couplings to do so.
-
Pull 6-pin connector off throttle valve control module -arrow-.
-
Open and close expansion tank cap to release pressure in cooling system.
-
Pull coolant hoses off throttle valve control module and seal hose ends.
-
Pull fuel supply hose -1- (with white marking) and fuel return hose -2- (with blue marking) off fuel rail and collect fuel that may leak out with a
cloth.
WARNING: Fuel system is under pressure! Before opening the system place a cloth around the connection. Then release pressure by
carefully loosening the connection.
-
Seal lines to avoid contamination of fuel system.
-
Observe rules for cleanliness, Refer to Powertrain Management, Fuel Delivery and Induction, Service and Repair