Jetta GLS L4-1.8L Turbo (AWP) (2002)
/Page-1311019.png)
Note:
^
When installing new gears or a new output shaft consult technical data
^
If the output shaft or tapered roller bearings have been replaced then perform output shaft adjustment.
1 - Clutch housing
2 - Shim
^
Always 0.65 mm thick
3 - Outer race/tapered roller bearing
^
Pulling out, Refer to Fig. 1
^
Pressing in, Refer to Fig. 2
4 - Tapered roller bearing inner race
^
Pulling off, Refer to Fig. 8
^
Pressing on, Refer to Fig. 20
5 - Output shaft
^
For 5th, 6th and reverse gear
6 - Reverse gear synchro-hub
^
Pressing off, Refer to Fig. 7
^
Installation position, Refer to Fig. 8
^
Pressing on, Refer to Fig. 10
7 - Securing clip
8 - Reverse gear locking collar
^
Securing clip
9 - Needle roller bearing
^
For reverse gear
10 - Reverse sliding gear
11 - Sleeve
^
Press off with reverse gear, Refer to Fig. 6
^
Installation position: wide shoulder of sleeve faces toward reverse gear
^
Pressing on, Refer to Fig. 11
12 - Securing clip
13 - Needle roller bearing
^
For 6th gear
