Jetta Sedan L5-2.5L (CBTA) (2009)
-
Remove the tie rod.
Installing
-
Insert the tie rod into the vehicle and tighten the bolts by hand.
-
Bring the wheel bearing housing into curb weight position. Refer to --> [ Wheel Bearing Housing, Lifting to Curb Weight Position ] See: Steering
and Suspension/Suspension/Service and Repair/Rear Suspension/Wheel Bearing Housing, Lifting to Curb Weight Position.
Only tighten the bolts if dimension "a" has been reached. Refer to--> [ between the wheel hub center and the lower edge of the wheel housing
has been attained. ] See: Steering and Suspension/Suspension/Service and Repair/Rear Suspension/Wheel Bearing Housing, Lifting to Curb
Weight Position!
-
Bolt the tie rod to the subframe and tighten the new nut.
-
Install and tighten the stabilizer bar bracket bolts - arrows -.