Jetta Sedan L5-2.5L (CBTA) (2009)
Specified value: Battery voltage.
If the specification was not obtained:
-
Check the wiring for an open, high resistance or short to Ground (GND) and replace any open fuse.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specification was obtained:
Checking Ground (GND) activation
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to --> [ Motronic Engine Control Module, Replacing ] .
-
Using a multimeter, check the Heated Oxygen Sensor (HO2S) (G465) electrical harness connector terminal 2 to the Motronic Engine Control
Module (ECM) (J623) electrical harness connector T121 terminal 63 for an open circuit.
Specified value: 1.5 ohms max.
If the specification was not obtained:
-
Check the wiring for an open or high resistance.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to --> [ Motronic Engine Control Module, Replacing ] .
-
Install the engine cover with air filter.
Final procedures