Jetta Sedan L5-2.5L (CBTA) (2009)
14
Needle bearing
15
5th gear drive gear
16
5th gear synchronizer ring
‹› With cast locking pieces --> [ 5th gear synchronizer ring with cast locking pieces ] See: Service and Repair/Overhaul/Disassembly and
Assembly Sequence
‹› Checking for wear --> [ Checking 5th gear synchronizer ring ] See: Service and Repair/Overhaul/Disassembly and Assembly Sequence
17
Spring
‹› Installed location --> [ Assembling 5th gear locking collar/synchronizer hub ] and --> [ Installation of offset springs ]
18
Locking pieces (Qty. 3)
‹› Installation position --> [ Synchronizing 5th gear ]
19
5th gear synchronizer hub
‹› Remove from --> [ Disassembly and Assembly Sequence ] See: Service and Repair/Overhaul/Disassembly and Assembly Sequence
20
5th gear locking collar
‹› Remove with 5th gear synchronizer hub from --> [ Disassembly and Assembly Sequence ] See: Service and Repair/Overhaul/Disassembly and
Assembly Sequence
21
Plate spring
‹› Installation position --> [ Installation position of plate springs for 5th gear synchronizer hub and gear-wheel securing bolts ] See: Service and
Repair/Overhaul/Disassembly and Assembly Sequence
22
Screw --> [ 4 Bolt, 80 Nm plus an additional 90° ] See: Service and Repair/Overhaul/Cover for Transmission Housing and 5th Gear
‹› Always replace
‹› Holds plate spring in position with fitting piece on bolt head --> [ Installation position of plate springs for 5th gear synchronizer hub and
gear-wheel securing bolts ] See: Service and Repair/Overhaul/Disassembly and Assembly Sequence
Pressing out tapered roller bearing outer race
Pressing in tapered roller bearing outer race