Jetta Sedan L5-2.5L (CBTA) (2009)
-
Remove noise insulation
-
Remove tunnel braces
-
Disconnect front exhaust system at double clamp and remove from subframe.
-
Disengage rear exhaust system and remove heat shield.
-
Pivot shift housing downward and remove with shift cables.
Installing
Install in reverse order, paying attention to the following:
The holes in the cable retainers have various diameters.
Allocation of cable retainers --> [ Allocation of cable retainers ] See: Shift Linkage/Shift Cable/Service and Repair
-
Spread a small quantity of grease (G 000 450 02) on pin - arrows - of transmission shift lever - 1 - and of actuator lever - 2 -.