New Beetle L4-1.8L Turbo (AWP) (2003)
Vehicles with engine code AWP, AWV, BKF, BNU
-
Check wires between test box and 2-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
terminal 2 + socket 64
Wire resistance: max. 1.5 ohms
Continue for all vehicles
-
Check the wire for short circuit to B+ and Ground (GND).
Specified value: Infinite Ohms
-
Check wire between 2-pin connector terminal 1 and the Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram.
Wire resistance: max. 1.5 ohms
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.