New Beetle L4-1.8L Turbo (AWP) (2003)
-
DO NOT ALLOW ELASTIC CABLE TO RETRACT INTO THE HEADLINING
-
Carefully remove elastic cable with retaining plate in direction of the arrow
-
Tie a strong one meter (3 ft) piece of string from the cable kit (1YM 898 001B) to the eyelet on a new elastic cable with retaining plate (1Y0
871 955A or 1Y0 871 956A)
-
Attach the cable guide tool JC 4200 to the end clip on the retaining plate and fully insert the retaining plate and elastic cable into headlining
-arrow- and remove the JC 4200 guide tool
IMPORTANT: When using the JC 4200 cable guide tool, pull elastic cable to keep tension against clip, otherwise tool will come off retaining
plate
NOTE:
-
Clips on retaining plate must face outwards
-
when inserted When retaining plate and elastic cable are fully inserted, only the string will be visible outside headlining
-
Push clips on retaining plate through holes in headlining
-
Obtain new slider (1Y0 871 341/A or 1Y0 871 342/A) from cable kit
-
Untie only knot -1- in the short lower cable
IMPORTANT:
-
Do not cut knot off new cable
-
Cable length must be maintained