New Beetle L4-1.8L Turbo (AWV) (2005)
-
Remove mounting bolts of ignition coil.
-
Remove ignition coil with power output stage vertically from spark plug.
Note the following when installing the ignition coils:
-
Replace ignition coil seal if damaged.
-
Push ignition coil by hand vertically onto spark plug.
-
Tighten securing bolts of ignition coil to 10 Nm.
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
Work procedure (vehicles with engine code AWP, AWV, BKF, BNU)
-
Disconnect corresponding 4-pin connectors -2- from the ignition coils -1-
NOTE: Before disconnecting harness connectors, mark allocation to component.
-
Remove ignition coil with power output stage vertically from spark plug using puller T40039.
Note the following when installing the ignition coils:
-
Replace ignition coil sealing ring if damaged.
-
Push ignition coil by hand vertically onto spark plug.
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.