New Beetle L4-1.8L Turbo (AWV) (2005)
-
Guide selector lever cable - 2 - into selector lever housing and press onto selector lever - 3 - with a screwdriver - 4 -.
-
Install new locking plate - 1 - in selector lever housing for selector lever cable.
-
Installation position:
-
Angled end of locking plate faces end of selector lever cable.
-
Lower vehicle.
-
Move pull rod upward and shift selector lever from position "P" to "S" with pull rod still held up.
-
Selector mechanism and selector lever cable must move freely when doing this, otherwise replace selector lever cable or service selector
mechanism.
-
Move pull rod upward and shift selector lever to position "P" with pull rod still held up.
-
Screw cover with bonded seal hand-tight onto selector lever housing.
Note: Ensure seal is positioned correctly.
-
First tighten nuts - arrows A -.
-
Then tighten 2 bolts - arrows B -.
-
Insert protective covering of selector lever cable into cover.