New Beetle L4-2.0L (AVH) (2005)
-
Remove protective cover (arrows) and disconnect 4-pin harness connector (brown) -1- to Oxygen Sensor (O2S) behind Three Way Catalytic
Converter (TWC) -G130-.
-
Connect multimeter for voltage measurement to terminals 3 + 4 of connector to Engine Control Module (ECM) and measure primary voltage.
Specified value: 0.400 to 0.500 Volts
-
Switch ignition off.
If specified value is not obtained:
-
Test oxygen sensor wires.
If specified value is obtained:
-
Replace Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130-.
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Checking oxygen sensor wires
-
Connect test box to control module wiring harness. connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
Vehicles with engine code AEG