New Beetle L4-2.0L (AVH) (2005)
/Page-1439007.png)
-
Route wiring harness - 5 - in prescribed channels in transmission as per illustration.
-
Observe the approximate distance - a - so that the wiring harness - 5 - does not lie against the planetary gearbox and be damaged when the vehicle
is in use.
-
Route wiring harnesses - 1 -, - 3 -, - 4 - and - 5 - over edge of transmission as per illustration.
-
Secure wiring harnesses to transmission with tape.
-
Ensure damper piston - 2 - is installed in transmission in position illustrated.
-
Moisten damper piston and mounting in transmission with ATF.
-
Insert springs into one another and insert into damper piston.
-
Insert damper piston with springs into mounting in transmission.
-
To prevent damper piston from falling out, push it into transmission until valve body is installed, if necessary.
-
Position valve body, using no force.
-
Ensure that wiring harnesses - 1 -, - 3 -, - 4 - and - 5 - are not trapped by valve body.
