Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


New Beetle L4-2.0L (AZG) (2003)

Sensors and Switches > Sensors and Switches - Lighting and Horns > Backup Lamp Switch > Component Information > Technical Service Bulletins > All Other Service Bulletins for Backup Lamp Switch: > 6109-02 > Mar > 09 > Interior - Headliner Is Loose Near Back Glass > Page 926

Page 2
background image

Tip:
-

Notches can be readily seen and felt around the periphery of the headliner .

-

Clips must be installed using flat pliers (plastic or with jaws protected) at the plastic beading edge

Clips must go over the plastic beading only (headliner cloth must not interfere).

-

Install clips at all notches (approximate locations indicated by arrows).

With 18 clips installed:

-

Insert beading into the rear glass headliner retainer groove.

With clips installed, it may be necessary to gently drive the beading into the retainer.

-

If necessary use a wide smooth edged nylon block and a rubber/plastic mallet against the cloth of the headliner (do not damage the headliner).

-

Tap lightly until beading is installed.

Headliner loose fit

2. When the headliner rear window beading for the rear glass fits loosely and comes out of the rear glass groove:

-

Remove headliner beading from rear glass by carefully pulling / prying it from the groove of the metal insert channel on the back glass (take
care not to damage headliner).

Sensors and Switches > Sensors and Switches - Lighting and Horns > Backup Lamp Switch > Component Information > Technical Service Bulletins > All Other Service Bulletins for Backup Lamp Switch: > 6109-02 > Mar > 09 > Interior - Headliner Is Loose Near Back Glass > Page 926

[PREV PAGE] [NEXT PAGE]