New Beetle L5-2.5L (BPR) (2007)
7
Self-locking nut
‹› M12 x 15
‹› Tightening specification => [ Wheel Bearing Housing ] See: Suspension/Specifications/Front Suspension.
‹› Never less than 90 degrees
‹› Torque angle tolerance 90 degrees to 120 degrees
‹› Always replace
8
Self-locking nut
‹› Always replace
‹› Tightening specification => [ Wheel Bearing Housing ] See: Suspension/Specifications/Front Suspension.
9
Wheel bearing housing
For vehicles:
‹› With gasoline engine up to and including 85 kW
‹› With TDI engine
10
Ball joint
‹› Removing and installing => [ Ball Joint ] See: Suspension/Ball Joint/Service and Repair.
11
Self-locking nut
‹› M12 x 15
‹› Tightening specification => [ Front Suspension Tightening Specifications ] See: Suspension/Specifications/Front Suspension.
‹› Always replace after removal
12
Cover plate
13
Hex bolt
‹› M6 x 10
‹› Tightening specification => [ Wheel Bearing Housing ] See: Suspension/Specifications/Front Suspension.
14
Self-locking 12 point nut
‹› Tightening => [ Tightening Specifications ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair/Removal and Replacement/Drive Axle with CV Joint and Triple Roller Joints AAR 2000 and AAR 2900.
‹› Always replace
15
Phillips-head screw
16
Vented brake rotor
17
Wheel hub with rotor for speed sensor
‹› Rotor is welded to wheel hub
‹› Removing and installing with wheel bearing housing installed => [ Front Wheel Bearing, Hub and Inner Race, with Wheel Bearing Housing
Installed ] See: Front Wheel Bearing, Hub and Inner Race, With Wheel Bearing Housing Installed.
18
Circlip