New Beetle Convertible L5-2.5L (BPR) (2007)
Alignment: Service and Repair
Checking Wheel Alignment
Checking Wheel Alignment
‹› The vehicle shows handling problems.
‹› Involved in an accident and components have been replaced.
‹› Axle components have been removed.
‹› Tires are worn on one side.
Wheel Alignment Test Prerequisites
Wheel Alignment Test Prerequisites
‹› Check suspension, wheel bearing, steering and steering linkage for excessive play and damage
‹› Tread depth difference of no more than 2 mm on an axle
‹› Tires inflated to prescribed pressure
‹› Curb weight of vehicle
Fuel tank must be full
Spare tire and vehicle tools are installed in appropriate position in vehicle
The water container for the windshield/headlight cleaning system must be full.
‹› Be sure that the sliding plates and turn tables are not touching the end stop when checking wheel alignment
‹› Test equipment must be properly adjusted and attached to the vehicle (see equipment manufacturer's instructions)!
If necessary, contact the manufacturer for familiarization with the proper use of the equipment.
After a certain period, wheel alignment platforms and computer equipment can lose their original leveling setting and adjustments.
Wheel alignment platforms and wheel alignment analyzer/computer should be serviced and calibrated at least once a year.
-
Precision equipment of this type should be treated with due care and knowledge.
Vehicle Data Label
Vehicle Data Label
Explanation of the PR. No. on vehicle data sticker
Different suspensions are installed depending on engine version and equipment. These are identified by PR numbers.