New Beetle GLS L4-1.8L Turbo (AWV) (2001)
^
Always replace after removing
^
Only replace as complete unit
^
Removing and installing
Refer to Transmission and Drivetrain.
6
- Bolt
^
Tighten to 60 Nm (44 ft. lbs.)
^
With dished spring washer
7
- Splash shield
8
- Stub axle
9
- Parking brake cable
^
Adjusting parking brake, Refer to Parking Brake.
10
- Axle beam
11
- ABS wheel speed sensor
^
Before inserting sensor, clean installation hole inner surface and coat with grease, Part No. G 000650
12
- Sockethead bolt
^
Tighten to 8 Nm (71 inch lbs.)
13
- Sockethead bolt
^
Tighten to 65 Nm (48 ft. lbs.)
14
- Brake carrier with guide pins and protective cap
^
Supplied as replacement part assembled with sufficient grease on guide pins
^
If protective caps or guide pins are damaged use repair kit. Use grease packet supplied to lubricate guide pins.
15
- Brake hose/line
^
With banjo bolt and seals
^
Banjo bolt to brake caliper tightening torque: 39 Nm (29 ft. lbs.)
^
Do not disconnect brake hose when changing brake pads
16
- Selflocking bolt
^
Tighten to 35 Nm (26 ft. lbs.)
^
Always replace
17
- Brake caliper
^
Adjust parking brake cable after maintenance or replacement.
^
Do not pull parking brake before adjusting it!
Refer to Parking Brake.
18
- Brake pads
^
Thickness 12 mm (0.472 inch)
^
Always replace brake pads on same axle on both sides of vehicle
^
Removing and installing, Refer to Brake Pads.
19
- Pad retaining springs
^
Always replace springs when changing pads
Disassembling and Assembling
Overview