New Beetle GLS L4-1.8L Turbo (AWV) (2001)
-
Connect test box to control module wiring harness, connect test box for wiring test.
-
Check wires between test box and 6-pin connector (to control module) for open circuit according to wiring diagram.
Terminal 1 + socket 70
Terminal 2 + socket 71
Terminal 5 + socket 51
Terminal 6 + socket 52
Wire resistance: max. 1.5 ohms
-
Also check wires for short circuit to B+ and Ground (GND).
Specified value: Infinite Ohms
If no malfunctions are found in wires:
-
Replace Heated Oxygen Sensor (HO2S) -G39- Bank 1 before catalytic converter, item 8
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/Read Measuring Value Blocks (Function 08)/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes