Passat (B3)
| Removing and installing rear lid lock (estate) |
| 1 - | Lock cylinder housing |
| q | To remove lock cylinder housing, trim of rear lid must first be removed |
| – | Remove cross-head screws → Item, unclip connector sleeve → Item from relay lever → Item. |
| q | If vehicle is equipped with central locking, also unclip release lever |
| q | Removing lock cylinder → Chapter |
| 2 - | Linkage clip |
| 3 - | Connector sleeve |
| q | When installing pull rod, press relay lever against lock cylinder and clip in connector sleeve |
| 4 - | Pull rod |
| q | Press relay lever → Item against stop and hook in pull rod stress-free |
| 5 - | Connector for luggage compartment light switch |
| 6 - | Lock |
| q | Before securing lock with bolts, insert connector and clip in pull rod (note item → Item) |
| 7 - | Countersunk bolt |
| q | 23 Nm |
| 8 - | Lock plate |
| 9 - | Countersunk bolt |
| q | 23 Nm |
| 10 - | Cross-head screw |
| q | 7 Nm |
| 11 - | Relay lever |
| q | 6 Nm |
