Passat (B3)
| Removing and installing covers and padding for (split folding) backrest |
| 1 - | Cover (double seat) |
| q | Removing and installing lock → Chapter |
| q | Remove centre armrest → Chapter |
| q | Removing and installing padding clips → Chapter |
| q | Seat cover is secured to rear wall flange with the sewn-in clamping profile |
| 2 - | Padding wire |
| q | Hooked into padding, attach and detach using awl -V.A.G 1636- |
| 3 - | Padding |
| 4 - | Backwall (double seat) |
| q | Self-adhesive trim, pull off protective film prior to assembly, add universal adhesive D 001 200 as necessary |
| 5 - | Head restraint |
| q | To remove, press button on guide and pull out head restraint |
| 6 - | Guide |
| q | To remove, release cover from backwall, press ends of guide together and pull out guide |
| q | Fitting position on saloon: button on guide must point to right |
| q | Fitting position on estate: button on guide must point to left |
| 7 - | Stop bar |
| q | Estate only |
| 8 - | Spacer block |
| q | Estate only |
| q | Secure in backwall with clips |
| 9 - | Backwall (single seat) |
| q | Self-adhesive trim, pull off protective film prior to assembly, add universal adhesive D 001 200 as necessary |
| 10 - | Socket head bolt |
| 11 - | Adapter |
| 12 - | Cover (single seat) |
| q | Removing and installing lock → Chapter |
| 13 - | Socket head bolt |
| 14 - | Adapter |
| 15 - | Bearing rod |
| q | For centre armrest |
| 16 - | Bracket for armrest |
| 17 - | Trim |
| 18 - | Box part |
| q | Note locking lug when removing and installing |
