volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Parts of cooling system - engine side > < Removing and installing parts of cooling system

Passat (B3)

4-cyl. fuel injection engine (cross-flow cylinder head)
Removing and installing parts of cooling system
Parts of cooling system body side
 
N19-0026
  • Retainer
  • 10 Nm
  • Radiator
    • ◆ Removing and installing
      =>Page 19-13
    • ◆ After replacing renew entire coolant
  • V-belt
    • ◆ Only with optional extras
  • Guide ring
    • ◆ Note fitting position
    • ◆ Secured to fan ring item 10 with clips
  • Radiator fan
    • ◆ Removing and installing
      =>Page 19-13
 
N19-0026
  • Upper coolant hose
    • ◆ To connection
      =>Page 19-5 , Item 1
  • Lower coolant hose
    • ◆ To coolant pump
      =>Page 19-6 , Item 16
  • Additional fan
    • ◆ Only with optional extras
    • ◆ Removing and installing
      =>Page 19-13
  • Fan ring
    • ◆ Note fitting position
  • Connector
  • Cover
  • Expansion tank
  • To connection
 
N19-0026
  • To ATF cooler
    • ◆ Only on vehicles with automatic gearbox
  • To cylinder head
  • To upper coolant hose
  • Cap
    • ◆ Check with V.A.G 1274 and 1274/4
    • ◆ Test pressure 1.4...1.6 bar
  • Thermo-switch (F18), 35 Nm
    • ◆ For electric fan
    • ◆ Switching temperatures:
      Stage 1
           on: 92...97 °C
           off: 84...91 °C
      Stage 2
           on: 99...105 °C
           off: 91...98 °C
  • Rubber bush

Parts of cooling system - engine side > < Removing and installing parts of cooling system