Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing drive plate >
< Removing and installing sealing flange and pressure plate/drive plate
Passat (B3)
Power unit
4-cyl. fuel injection engine (cross-flow cylinder head)
Enginecrankshaft group, pistons
Removing and installing sealing flange and pressure plate/drive plate
Renewing crankshaft oil seal - pulley end -
4-cyl. fuel injection engine (cross-flow cylinder head)
Removing and installing sealing flange and pressure plate/drive plate
Renewing crankshaft oil seal - pulley end -
Special tools, testers and auxiliary items
◆
Counter-hold tool 3099
◆
Oil seal extractor 2085
◆
Oil seal fitting tool 3083
Removing
‒
Remove ribbed belt .
‒
Remove toothed belt => Page
13-17
.
‒
Remove crankshaft sprocket. To do this counter-hold sprocket with 3099.
‒
Unscrew inner part of the oil seal extractor 2085 two turns (approx. 3 mm) out of the outer part and lock with knurled screw.
‒
→ To guide the oil seal extractor, screw bolt from 3083 into crankshaft as far as it will go.
‒
→ Lubricate threaded head of oil seal extractor, place it in position and exerting firm pressure screw it as far as possible into oil seal.
‒
Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out.
Installing
‒
Lightly oil sealing lip of oil seal.
‒
→ Place guide sleeve from 3083 onto crankshaft journal.
‒
Slide oil seal over guide sleeve.
‒
→ Press oil seal in onto stop with press sleeve from 3083.
‒
Install and tension toothed belt => Page
13-17
Power unit
4-cyl. fuel injection engine (cross-flow cylinder head)
Enginecrankshaft group, pistons
Removing and installing sealing flange and pressure plate/drive plate
Renewing crankshaft oil seal - pulley end -
Removing and installing drive plate >
< Removing and installing sealing flange and pressure plate/drive plate