volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling oil pump > < Removing and installing parts of the lubrication system

Passat (B3)

6-cyl. fuel injection engine Mechanics
Removing and installing parts of the lubrication system
Dismantling and assembling oil filter housing
 
N17-0005
  • Gasket
    • ◆ Renew
    • ◆ Note fitting position
    • ◆ Oil before installing
  • 0.3 bar oil pressure switch (F22), 20 Nm
    • ◆ Brown
    • ◆ Wiring: blue/black
    • ◆ Checking
    • ◆ If sealing ring is leaking nip open and replace.
  • Oil filter bracket
  • Stop plate
    • ◆ For oil cooler
    • ◆ Secured to oil filter bracket
 
N17-0005
  • Oil filter element
    • ◆ Observe change intervals
    • ◆ With by-pass valve
           Opening pressure: 2.0 bar
    • ◆ Clip into oil filter lower part before installing
  • O-ring
    • ◆ Renew
    • ◆ Oil before installing
  • Oil filter lower part, 30 Nm
    • ◆ Drain before removing
  • Oil drain screw, 10 Nm
  • 25 Nm
 
N17-0005
  • 1.4 bar oil pressure switch (F1), 25 Nm
    • ◆ Black
    • ◆ Wiring: yellow
    • ◆ Checking => Page 17-14
    • ◆ If sealing ring is leaking nip open and replace.
  • Oil temperature sender (G8), 10 Nm

Dismantling and assembling oil pump > < Removing and installing parts of the lubrication system