Notes:
-
◆ If the display on fault reader jumps by 2...5 °C, it is a control unit fault and not caused by a defective sender.
-
◆ Open circuit is indicated by - 49.5 °C.
-
◆ If irregular engine running occurs in certain temperature ranges and the temperature figure does not increase without interruption, the temperature signal is temporarily interrupted and the sender must be renewed.
-
‒ Press ⇒ key.
-
‒ In put 06 for "End output" and confirm with Q.
If the temperature figure does not change:
-
‒ Carry out electrical check, test step 9
=> Page 01-20
, renew coolant temperature sender (G62) if necessary, (first release pressure from cooling system).
<SOURCEMARKET>
</SOURCEMARKET>
<SOURCESYSTEM>
</SOURCESYSTEM>
|