Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Engine, Cooling and Exhaust > Engine > Actuators and Solenoids - Engine > Variable Valve Timing Actuator > Component Information > Service and Repair > Camshaft Adjuster With Timing Chain, Installing > Page 1816
Remove the (T10068 A).
Install the camshaft timing chain tensioner and tighten it to 50 Nm.
Rotate the crankshaft 2 revolutions in engine rotation direction and check the valve timing. Refer to => [ Valve Timing, Checking ] See: Cylinder
If the mark match:
Secure the respective camshaft to be tightened using a 27 mm open end wrench on the recess - arrow -.
‹› The (T10068 A) must not be installed during this process.
‹› Be aware that all sprocket bolts must be replaced.
Tighten the new bolts for the intake and exhaust camshaft adjusters to 60 Nm + 90° (1/4) additional turn.
Install the sealing flange. Refer to => [ Sealing Flange, Transmission Side ] See: Cylinder Block Assembly/Crankshaft Seal Retainer/Service and
Vehicles from 12.08
Special tools, testers and auxiliary items required
‹› Camshaft Bar (T10068 A)
‹› Counter-Holder Tool (T10069)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Torque Wrench (40-200 Nm) (V.A.G 1332)
‹› Adjustment Tool (T10332) (Without a mechanical vacuum pump)
‹› Adjustment Tool (T10363) (With a mechanical vacuum pump)
‹› Sealant (D 176 501 A1)
Rotate the crankshaft in engine rotation direction to Top Dead Center (TDC) for cylinder 1.
|[PREV PAGE] [NEXT PAGE]|