Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Engine, Cooling and Exhaust > Engine > Actuators and Solenoids - Engine > Variable Valve Timing Actuator > Component Information > Service and Repair > Camshaft Adjuster With Timing Chain, Installing > Page 1825
Pull the camshaft adjustment valve out of control housing against the loosened bolts.
Completely remove the bolts and remove the camshaft adjustment valve from the control housing.
‹› The camshaft adjustment valves and control housing must be free of dust and contamination.
‹› The camshaft adjustment valves must not be subjected to knocks or impacts.
‹› Only remove the new camshaft adjustment valve from its packaging right before installation.
‹› Camshaft adjustment valves must not be pulled into valve the seat by the bolts. Only press them in by hand.
Lubricate the seal with clean engine oil.
Carefully install the camshaft adjustment valve into the housing and press it in perpendicular to the valve axis by hand until its seated.
Tighten the bolts - arrows - to 3.8 Nm.
- 1 - camshaft adjustment valve 1.
- 2 - camshaft adjustment valve 1 (exhaust).
Clean the sealing surfaces on the timing chain cover and on the cylinder head.
|[PREV PAGE] [NEXT PAGE]|