Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Crankshaft Seal Retainer > Component Information > Locations > Page 1916

Page 2
background image

residue from falling in.

-

Using a rotating plastic brush, remove the remaining sealant from the sealing flange and cylinder block. Wear safety glasses.

-

Clean sealing surfaces, must be free of oil and grease.

-

Clean the holes - arrow - in cylinder head gasket of old sealant.

‹› With the cylinder head installed, the holes in the cylinder head gasket are only half visible.

CAUTION!
The cylinder head gasket could be damaged. The cylinder head gasket can kink if it is bent too much. A kinked cylinder head gasket must
be replaced.

-

Bend the end of the cylinder head gasket down slightly -  arrows - until the upper sealing surface of the cylinder head gasket and cylinder head
can be cleaned.

Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Crankshaft Seal Retainer > Component Information > Locations > Page 1916

[PREV PAGE] [NEXT PAGE]