Passat Sedan V6-3.6L (BLV) (2008)
Valve Cover: Service and Repair
Cylinder Head Cover
Special tools, testers and auxiliary items required
‹› Spring Type Clip Pliers (VAS 5024 A)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Assembly Tool (T10118)
‹› Puller For Ignition Coil (T10095 A)
Removing
‹› To perform this procedure, the ground cable must be disconnected from the battery. If a coded radio is installed, obtain the anti-theft code
beforehand.
-
With the ignition turned off disconnect battery ground cable.
-
Any cable ties which are opened or cut off when removing, must be replaced in the same position when installing.
-
Remove the ignition coils with power output stage. Refer to => [ Ignition Coils with Power Output Stages ] See: Powertrain Management/Ignition
System/Ignition Coil/Service and Repair.
-
If equipped with a one piece intake manifold, remove the intake manifold. Refer to => [ Intake Manifold ] See: Intake Manifold/Service and
Repair/One Piece Intake Manifold.
-
If equipped with a two piece intake manifold, remove the upper intake manifold. Refer to => [ Upper Intake Manifold ] See: Intake
Manifold/Service and Repair/Two Piece Intake Manifold.
‹› Seal the intake passages in the intake manifold and in the cylinder head with clean cloths.
-
Disconnect all other electrical wires from the cylinder head cover and set them aside.
-
Loosen the cylinder head cover bolts starting from the inside and working toward the outside - 17 through 1 -.
-
Remove the bolts and remove the cylinder head cover.
Installing
-
Apply sealant (D 454 300 A2) to the marked locations - arrows - on the timing chain cover cover.