Passat Sedan V6-3.6L (BLV) (2008)
‹› Vehicles from 08.07 have a low pressure hose that is secured with hose clamps instead of union nuts. The low pressure hose secured with hose
clamps must always be replaced because it is damaged when it is removed from the ridged connection.
Installing
-
Check the high pressure pump plunger for damage; replace it if necessary.
-
Insert the lubricated plunger - 1 - with guide - 2 - perpendicularly into the cylinder head.
-
Rotate the engine at the vibration damper slowly in engine rotation direction. When doing this, press the plunger in the - direction of the arrow -
until it reaches the deepest point in the cylinder head.
-
Replace the high pressure pump O-ring.
-
Install the high pressure pump and evenly tighten the bolts - arrows -.