Passat Sedan V6-3.6L (BLV) (2008)
Install and tighten the bolts for the intake manifold supports.
The rest of the installation is basically a reverse of the removal sequence.
Tightening specifications, refer to => [ Intake Manifold Overview ] See: .
Lower Intake Manifold, With Fuel Rail
Two Piece Intake Manifold
Lower Intake Manifold, with Fuel Rail
Special tools, testers and auxiliary items required
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Assembly Tool (T10118)
‹› Read the safety precautions before beginning work. Refer to => [ Safety Precautions ] See: Powertrain Management/Fuel Delivery and Air
Induction/Service Precautions/Safety Precautions/Fuel Supply.
‹› Observe the rules for cleanliness. Refer to => [ Clean Working Conditions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Clean Working Conditions/Multiport Fuel Injection.
‹› If a fuel injector is removed, the combustion chamber Teflon seal and O-ring must be replaced. Refer to => [ Fuel Injector Teflon Seal and Washer
‹› The seal - item 13 -=> [ Seal ] See: must also be replaced for the fuel injectors for cylinders 1, 3 and 5.
‹› If the fuel rail is removed, the fuel injector spring - arrow - must be replaced.