Passat Sedan V6-3.6L (BLV) (2008)
-
Remove the (T10068 A).
-
Install the camshaft timing chain tensioner and tighten it to 50 Nm.
-
Rotate the crankshaft 2 revolutions in engine rotation direction and check the valve timing. Refer to => [ Valve Timing, Checking ] See: Cylinder
Head Assembly/Testing and Inspection.
If the mark match:
-
Secure the respective camshaft to be tightened using a 27 mm open end wrench on the recess - arrow -.
‹› The (T10068 A) must not be installed during this process.
‹› Be aware that all sprocket bolts must be replaced.
-
Tighten the new bolts for the intake and exhaust camshaft adjusters to 60 Nm + 90° (1/4) additional turn.
Install the sealing flange. Refer to => [ Sealing Flange, Transmission Side ] See: Cylinder Block Assembly/Crankshaft Seal Retainer/Service and
Repair.
Vehicles from 12.08
Special tools, testers and auxiliary items required
‹› Camshaft Bar (T10068 A)
‹› Counter-Holder Tool (T10069)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Torque Wrench (40-200 Nm) (V.A.G 1332)
‹› Adjustment Tool (T10332) (Without a mechanical vacuum pump)
‹› Adjustment Tool (T10363) (With a mechanical vacuum pump)
‹› Sealant (D 176 501 A1)
-
Rotate the crankshaft in engine rotation direction to Top Dead Center (TDC) for cylinder 1.